Cam change

[MR.hp]

Cam change and intake swap next week in the bird

[smooth_358]

hurray progress! I probably won't end up making any changes this year...

[MR.hp]

Ya I got get going on things as the nicer wheather has arrived. I will need to pull some all nighters again since I don't have to get up early anymore. Hope the changes help when I redyno it at Haley's again.

[smooth_358]

is he keeping his shop open? last time i talked to him it was supposed to be gone by april?

[MR.hp]

I am not sure what John is doing but when I am done if it's still there I will get the bird dynoed.
Pulled the cam today, What a little cam
.412 I 193 duration@.050
.428 E 198 duration@.050 on a 111 LCA

The new cam or the HOT cam I have should make quite a difference along with the air gap intake.

[MR.hp]

Today's job was to grind all the rockers and make them long slot rockers, Don't need no binding or breaking rocker studs.

[Guest]

i have a slightly larger cam and springs for ya.

[MR.hp]

i have a slightly larger cam and springs for ya.

I have about 10 other cams for SB and most are pretty nasty, Make some good power manners are well less than drivable.

When I put the 4spd in the car it will most likely get the motor that's in the camaro now. That has a 292H in it but I will switch that to the 282S I have before I put itin the car. I like solid lifters. Thanks for the offer though.

[MR.hp]

Car is just about done.

[MR.hp]

IT RUNS boy for a cam that has 218 and 228 duration on a 112CL it sure sounds like a puppy cam, But that's what I wanted. I am sure the elgin hyd I have on the shelf would make this engine sing but that is for another project to be completed in august along with the 4 speed conversion.